Tim Watson

Here are some pics of my AC bracket I made and installed

Here is a shot of the mainbrace made of stainless, and bolted to the two bosses on the front right of the Chevy block.

The side shot of the bracket shows some support on the rear of the compressor, unfortunately I only had room to tie into only one side of the rear mounting boss. Hopefully with the three points tie together it should hold up. I used the stock Hamilton AC compressor off the 84 Fiero

The shot of the front shows the belt adjustment rod on the bottom tied into the Alt bracket. The Alt bracket is one I picked up at the swap meet, the rod guys use them a lot. I used double short W/P pulleys, and I have no power steering pump to mount.