ChassisElectricalFrontRearBodyInteriorNotes
Chassis - Fiero - Chassis

Dale "doc" Smith

8/3/03 - I went to Allentown home of D&R on 2 occasions before buying their roadster. I had my fiero at that time and wanted to build as much as I could before bringing the body home. I took a big bunch of digital photos on each trip to supplant the measurements I took so I could keep building. Here are many of the photos I took of Rick's turnkey he was working on. Subsequently, the buyer of the turnkey changed engine specs and they cut the whole rear end off to accommodate the V12 in a different frame suspension.

I have a lot more close ups of the various important areas as well as the measurements. I realized however you can only go so far without the body before you have to have it on so that you don't weld a ton of stuff in place and find one tiny little starting measurement was off by 1/2 ". When I got my body home thank goodness I was on the money for what I had done. PICS of my project soon.
DSC00011.jpg (213kb) DSC00013.jpg (167kb) DSC00026.jpg (196kb) DSC00031.jpg (203kb) DSC00032.jpg (193kb)
DSC00033.jpg (184kb) DSC00038.jpg (238kb) DSC00039.jpg (195kb) DSC00044.jpg (226kb) DSC00052.jpg (225kb)
DSC00055.jpg (256kb) DSC00058.jpg (198kb) DSC00062.jpg (186kb) DSC00065.jpg (156kb) intubr.jpg (205kb)
No3.jpg (194kb) No6.jpg (206kb) NoA1A.jpg (176kb) wspst.jpg (195kb)  

 

 

 

This entire web site is Copyright © 2002- www.lambolounge.com by Ron Fletcher. All rights reserved.
 
Although my information comes from various builders and sources, if you want any information contact me. The photographs used on this site are used with permission, if you want to use any, contact them through the various links on this site. I did and you can see the results!