ChassisElectricalFrontRearBodyInteriorNotes
Chassis - Fiero Shifter

 

Dwight Booth

New set of challenges.

Fiero Shifter angles back too far.

The entire sift bracket on floor cannot compensate for angle / interference.

I had to:
- Cut out welds.
- Grind surfaces.
- Reposition and mark lever 180 degrees
- Validate that goal was met.

 

 

This entire web site is Copyright © 2002- www.lambolounge.com by Ron Fletcher. All rights reserved.
 
Although my information comes from various builders and sources, if you want any information contact me. The photographs used on this site are used with permission, if you want to use any, contact them through the various links on this site. I did and you can see the results!