| |
|
|
|
|
|
|
| |
|
|
|||||||
|
|||||||||
| Chassis - Fiero - Sub Frame |
Mark Wittl I just finished my chassis which is a custom tube built on top of a stretched
Fiero. |
 |
 |
 |
 |
|
Added a 12" removable section to the rear cross member of the subframe for the removal of the stock gas tank.
|
 |
 |
 |
Diagnal Brace Added 1X3 diagnal braces to upper firewall. I will tie into under carrage subframe once engine location and clearances are determined
|
Firewall support Here are the first few braces added for the firewall and body support. I will be adding more braces once my air tank for suspension, wiper motor bracket/ and battery tray are installed.
|
 |
 |
Rear frame notch Will have to notch rear frame cross member to make
clearance for Audi 5000 transmission. Yellow lines will be cut out and
then capped |
Cradel test fit Installed engine to make sure clearances work on
crossmember supports |
|
These are photos that Steve of CRP sent me of his sub frame for $4,000, which attachs to the Fiero passenger tub. |
 |
 |
 |
 |
This entire Website
is copyright © 2002-2005 by Ron
Fletcher. All rights reserved. |
Although my information
comes from various builders and sources, if you want any information contact
me. The photographs used on this site are used with permission, if you
want to use any, contact them through the various links on this site.
I did and you can see the results! |
