| |
|
|
|
|
|
|
| |
|
|
|||||||
|
|||||||||
| Chassis - Rear End - Lamborghini |
 |
|
This is something you don't see every day... the view of the underside of a Diablo 6.0 |
 |
These comments are from Andy Bujtas: I looked pretty closely at those 6.0 rear suspension pictures and can say that Lambo's weld quality doesn't look too good. As a matter of fact, you can see a blow hole in the weld of one of their exhaust pipes. |
 |
These comments are from Andy Bujtas: Their rear suspension looks like it can easily be replicated using the stock Fiero upright. I've already given such an idea, and how to make, it to Jed Copham: lower wishbone (or H-arm), single upper link with longitudinal link (triangle) and dual coil-over's per side. All based around the Fiero (actually the Chevy Celebrity) upright. It would be relatively easy to make and would provide a heck of a lot better handling than the current McPherson (or '88 Chapman) strut model. |
 |
 |
 |
| Keith Billanti took these photos |
 |
 |
 |
|
Here are some Suspension pictures I had of the real thing. Notice the New England rust and dirt. Of course its still no excuse and the owner should be banned from the Lambo society for letting it get that dirty. |
 |
 |
 |
| This is the rear suspension | |
 |
 |
| I few shots of the front right side | |
| Jed Copham |
 |
 |
 |
 |
 |
 |
 |
| Photos from e-bay |
 |
 |
This entire Website
is copyright © 2002-2005 by Ron
Fletcher. All rights reserved. |
Although my information
comes from various builders and sources, if you want any information contact
me. The photographs used on this site are used with permission, if you
want to use any, contact them through the various links on this site.
I did and you can see the results! |