ChassisElectricalFrontRearBodyInteriorNotes
Chassis - Tube Chassis Frames Back to Tubular Frame Memu

Mike Budgery

I'm using a 84 Fiero for the tub and the front end suspension. I have designed my own tubular rear end and under tub support struction. I have already done analysis on frame. I am a mechanical engineer with lots of structural experience.
Top view of the rear end chassis build

Front Right Suspension
This is a shot of my front right susp. The reason i took so long was I had to redo my lower control arm after my last conversation on the forum. The lower ball joint is standard. I'm in the process of making a new front cradle. This will be complete once i get the left side mounted. Thanks for everyones input on correcting my earlier mistake.


 

This entire web site is Copyright © 2002- www.lambolounge.com by Ron Fletcher. All rights reserved.

Although my information comes from various builders and sources, if you want any information contact me. The photographs used on this site are used with permission, if you want to use any, contact them through the various links on this site. I did and you can see the results!