| |
|
|
|
|
|
|
| |
|
|
|||||||
|
|||||||||
| Front
- Bumper - Turn Indicator |
| A real Lamborghini | |
 |
 |
photos by Ron Boudreau - This is from a collection of photos of a 97 Roadster |
|
|
This is what the lights look like as I got them from Kitcar Accessories - John Rudl for $92 each (there is a right and a left light). |
|
 |
 |
 |
 |
| Before I cut the hole |
I cut out the body for the light - I will mount
my light from the inside |
 |
add photo |
| This is the inside of the bumper - I installed
(bondo) two pieces of 1/8 steel into the sides of the bumper to hold the
steel in place. |
This photo was taken from the inside to show the steel fiberglassed
in. |
 |
 |
| This show the front side of the steel pieces |
A close up |
| These are photos and comments from other builders about there installation methods. |
|
I am using original Lamborghini parking lights. It was necessary to fabricate a frame with tabs on either end. I will weld a tab for the screws to be fastened to when the lights are finally positioned. The tabs are then bondoed to the body and glassed in. The lights were trial fitted and then bonodo was used to form the new shape to match the lights. |
 |
 |
 |
| Links: |
| Kit Car Accessories |
| North American Exotic Replica Car |
 |
This entire Website
is copyright © 2002-2005 by Ron
Fletcher. All rights reserved. |
Although my information
comes from various builders and sources, if you want any information contact
me. The photographs used on this site are used with permission, if you
want to use any, contact them through the various links on this site.
I did and you can see the results! |
