ChassisElectricalFrontRearBodyInteriorNotes
Interior - Shifter

 

A real Lamborghini This is a center console shifter from a 6.0 Diablo

 

These are photos and comments from other builders about there installation methods.

 

Dale Van Blokland

I made a shifter boot by cutting a ring out of ABS and then drilling holes through the carbon fiber to hold it in place with screws. I made a pattern for the boot, sewed it together, leaving an opening for the shift rod, and then glued the bottom to the ring. The ring was then fastened to the carbon fiber for a completed boot.

 

This entire web site is Copyright © 2002- www.lambolounge.com by Ron Fletcher. All rights reserved.

Although my information comes from various builders and sources, if you want any information contact me. The photographs used on this site are used with permission, if you want to use any, contact them through the various links on this site. I did and you can see the results!