Lambo Lounge - Diablo Kit Car

Rear - Tail Lights - Mounting

Dale Van Blokland I started again finishing my bezels. I had not used the undercoat for the candy apple red. I sanded them down again and started with the base coat. Two coats of candy apple red finished by clear coat. The finished picture doesn't do it justice.

Because I am using original taillights from Lamborghini. it is necessary to cut out the bezels and mount them to the back of the car. I have used epoxy to mount 1/4" bolts inside the bezel after I had removed the coating. Once the epoxy was dry I drilled holes where the bolts would go through the body and marked where the openings needed to be for the lights. I have had two of the bolts come loose from the bezel so I may have to try something different. Duncan Smith used bondo with a super adhesive spray which may be my next option.


Here are the openings and the bolt holes that have been drilled. You can see where the coating was removed inside the bezel to epoxy the bolts in. I sprayed the outside with primer and will paint them a candy apple red with clear coat when I am done.

Although my information comes from various builders and sources, if you want any information contact me. The photographs used on this site are used with permission, if you want to use any, contact them through the various links on this site. I did and you can see the results!